maxxecu

Mounting brackets for MaxxECU GEN2.Includes brackets, lists, rubber bushings, and all screws for both sides of the ECU.

3 meter long, 480mbit/s.

3meter, 480mbit/sRight-angle (90°) USB-C connector on the MaxxECU side.

3meter, 480mbit/s

3meter, 480mbit/sRight-angle (90°) USB-C connector on the MaxxECU side.

34-pin superseal 1.0. Including terminals.

34-pin superseal 1.0. Including terminals.

34-pin superseal 1.0. Including terminals.

34-pin superseal 1.0. Including terminals.

AN3 MAP sensor nipple for GEN2 MaxxECU units.BSP 1/8 inch thread.Black anodized aluminum.

MAP sensor hose nipple for GEN2 MaxxECU units.BSP 1/8 inch thread.Black anodized aluminum.

Introducing MaxxECU GEN2 RACE – the ultimate engine control system for tuners and racing professionals. When every millisecond matters, on the street, track or dragstrip, the GEN2 RACE gives you access to virtually all engine data, allowing you to fine-tune every aspect for peak...

All cables are 3m long.

All cables are 3m long.

All cables are 3m long.

All cables are 3m long.

Only for MaxxECU GEN2 TRACK.All cables are 3m long.Extends the MaxxECU GEN2 TRACK with input and output functions.

34-pin superseal 1.0.Including terminals and plugs to cover unused pins on the GEN2 TRACK.We are currently awaiting a custom-made connector with MX3 keying, designed exclusively for the MaxxECU GEN2 TRACK, without holes for the unused pin positions. Until it becomes available, product will be...

Must be mounted for the unit to be water-protected.

Wires to MaxxECU IGN output, can be used as ignition amplifier, or to directly drive a NOS solenoid. 30A peak 10A nominal REQUIRES to be mounted on a bigger surface to divert heat.

Advanced entry-level engine control system for up to 4 sequential cylinders. Up to 8 in wasted spark. Faster and easier tuning with the built-in MAP-sensor up to 3 bar / 43.5 psi of boost. Get started faster with the easy-to-use MTune PC-software Specs: Waterproofed...

For own manufacturing of wiring harness. For MaxxECU MINI, RACE connector 2 and PRO connector 4. NOTE: Special crimping tool is needed!

NOTE: Only for advanced users and this product has no guarantee as soldering takes place outside our control.MAP sensor hose and clamp is included. Board is 65x70mm. MaxxECU MINI uses the same easy to use, yet powerful MTune software. Specs: 4 injector (high impedance...

MaxxECU wiring harness for MINI.

1.8m (6FT) micro USB cable for MaxxECU MINI

The MaxxECU PDM20 is an advanced Power Distribution Module for MaxxECU units and is designed to replace fuses and relays in a modern way. Specs: Max 230A. 20 outputs (8x25A, 8x15A, 4x8A). 7 digital / analog (0-24V) inputs. All outputs can be PWM controlled....

Including terminals. For PDM20 connector 1.

Including terminals. For PDM20 connector 2.

MaxxECU wiring harness for PDM.