Elektroonika

Trigger wheel 100mm / 57mm (60-2) Trigger wheel for which fits aftermarket ECU to get crankshaft signal. These are available in 36-1 or 60-2 resolution which is preset in all aftermarket control systems. Used in conjunction with a Hall or VR sensor connected to...

Crank trigger VAG 60-2 60-2 trigger mounted instead of rear oil seal and brings a 60-2 trigger from the supplied digital trigger sensor. MaxxECU takes this signal directly without any external electronics.Connectors not included! Fits Audi 5-cyl engine1: +5v2: Signal3: Trigger GND.

Bosch wide band sensor LSU 4.9 (0281 004 191

Temperature sensors. CLT sensor for water / oil temperature. M14x1.5mm thread Calibration table and connection see the image above.

Camposition sensor Volvo 850 Suits the cam position adapter for B230 Hall effect sensor/ camshaft sensor 0232101023 (0 232 101 023) Illustration of the pin-out is avalible in the pictures.

SPAL cooling fan 385mm / 16" suction HD Voltage: 12 V Power consumption: 235W Engine type: Long life IP68Specification: 1-speed, suctionVolume: max 3430 m³/h Diameter [mm]: 385 mm / 16"Depth: 88 mm Weight: 2,57 kg

Trigger disc camshaft Volvo 850 Suits the cam position adapter for B230

SPAL cooling fan 385mm / 16" blowing HD Voltage: 12 V Power consumption: 260 W Engine type: Long life IP68Specification: 1-speed, blowingVolume: max 3320 m³/h Diameter [mm]: 385mm / 16"Depth: 88 mm Weight: 2,57 kg

Ignition cable clip kit

Ignition cable clip

Bosch Motorsport ignition coil waste fire. 6 cylinders (2 can be used on 12 cylinders) Pin1 = coil 3 Pin2 = coil 2 Pin3 = coil 1 Pin4 = 12volt +

MSD ignition cable Red Price per meter

MSD Ignition Wire Black MSD 8.5mm ignition wire. Fits the spark plug boots that can be selected on this website. MSD ignition wire approx. 50 ohms per foot or approx. 150 ohms per meter.An ignition wire used for high power outputs on modified cars,...

Ecu Master EMU Classic Flying Lead Wiring Harness High-quality flying lead harness for EMU Classic with pre-crimped pins on one end, ready to be easily connected to the connectors.Each wire is labeled with a designation for its specific channel.

Ecu Master EMU Black Flying Lead Wiring Harness High-quality flying lead harness for EMU BLACK with pre-crimped pins on one end, ready to be easily connected to the connectors.Each wire is labeled with a designation for its specific channel.

Cam position adapter Volvo B230 Adapter to fit camshaft sensor on camshaft to enable sequential ignition with aftermarket engine management system on Volvo red engine with distributor on camshaft mounted original. Used with camshaft sensor 0232101023 (0 232 101 023) The adapter is used...

ECU Master EMU bluetooth module The Bluetooth module allows the transmission of ECUMASTER log data via Bluetooth communication. It also makes it possible to trace all important engine parameters in real time using Android-compatible devices. There is also a third party Dashboard application available....

ECU Master EMU Can-bus Bluetooth Module The CAN Bus Bluetooth adapter for ECUMaster EMU Black enables wireless display of ECU parameters on an Android tablet or phone. This adapter is intended for the CAN version of EMU (with 6 pins on the expansion port...

ECU Master Classic ECU Master EMU Classic is a highly advanced and modern engine management system that can control both 2-stroke and 4-stroke engines in sequential up to 6 cylinders or waste-fire up to 12 cylinders. EMU Black has built-in support for CAN-BUS, EGT,...

ECU Master PMU-16DL A few decades ago, the most critical electronic components in a race car were the ignition coil and distributor. Today, race cars are equipped with advanced engine management systems, braking systems, paddle shifters, data loggers, radios, electric pumps, fans, and lighting....

ECU Master Black ECU Master EMU Black is a highly advanced and modern engine management system that can control both 2-stroke and 4-stroke engines in sequential up to 6 cylinders or waste-fire up to 12 cylinders. EMU Black has built-in support for CAN-BUS, EGT,...

Bulkhead feedthrough bushing Cable grommet for bulkhead. Used to protect cables and hoses that need to pass through a plate / bulkhead from chafing. For 55mm hole 15mm hole for cables, highly stretchable to about 25-27mm diameter

SPAL cooling fan 350mm / 14" blowing HD Voltage: 12 V Power consumption: 255 W Engine type: Long life IP68Specification: 1-speed, blowingVolume: max 3120 m³/h HDDiameter [mm]: 350mm / 14"Depth: 88 mm Weight: 2,35kg

Digital cam position sensor for cam position detection. Pulldown output. Requires pulse resistance (usually built in ECU). Use with steel trigger. 5-24v supply voltage.Including lock nuts for sensor mounting. This also works as a general crank trigger (tested with 60-2 trigger wheels up to...